[toc]
Set up your camera and hard hat before you go to site. Use a camera from Supported 360° Cameras; other models are not supported.
Insta360 cameras
| Camera | Setup guide |
|---|---|
| X6 | No separate setup article yet. Connect it to your computer in File Transfer mode; CupixConnect recognizes the X6 from version 2026.3.3. |
| X5 (recommended) |
Insta360 X5 Basic Setup Insta360 X5 Manual Firmware Update |
| X4 | Insta360 X4 Basic Setup |
| ONE RS 1-Inch | Insta360 ONE RS 1-Inch Basic Setup |
| ONE X2 | Insta360 ONE X2 Basic Setup |
- Insert a microSD card into the camera.
- Update the camera firmware. See Updating Camera Firmware.
- Change the camera's USB mode so your computer can find it. Your camera's Basic Setup article shows how.
- Fully charge the camera.
Note: The Insta360 X3, X4 Air and ONE RS (non 1-Inch editions) are not supported.
Ricoh cameras
| Camera | Setup guide |
|---|---|
| Theta X | Ricoh Theta X Basic Setup |
| Theta Z1 | Supported for 360° panoramas only. CupixWorks does not build a 3D dollhouse from Theta Z1 captures, so it is not recommended when you need a 3D walkthrough. |
- Use the onboard storage, or insert a microSD card.
- Update the camera firmware. See Updating Camera Firmware.
- Fully charge the camera.
Hard hat setup
- Install the suspension mount (video).
- Install the camera mount.
Next
After a capture, see Download Image Files from a Camera to move the files to your computer, then upload them with CupixConnect.