[toc]
A BIM file (Revit, Navisworks, IFC or SketchUp) does not need extracting. As soon as it is Ready in the Library, it shows 1 DR: one 3D BIM reference, with the model's views, levels and rooms inside it. To bring in a second model, upload a second file.
This article shows what the 3D BIM editor holds and what to do before you align the model.
Open the model in its editor
- Open Project Admin Center > Library and wait until the file shows Ready.
- Select the file. Its details open on the right.
- Click Open in Editor at the bottom of the panel. The 3D BIM editor opens in a new tab.
What the model brings in
The 3D BIM opens in Draft, with the model in the middle, its contents on the left and its properties on the right.
- 3D Views, Levels, Rooms, Work Area - what the model brings with it, one tab each.
- 3D Views - the views saved in the model file. Main marks the default view.
- Default and Publish - the star sets the view that opens first; the switch decides which views reach the apps.
- Status - Draft, Aligned, Activated. Next: finish alignment says what to do next; Open Alignment tab takes you there.
- Survey point - read from the model file. Turn on Adopt Survey Point as the Building's geo-reference to let it set where the building sits on the map.
Levels
- Populate Levels to Building - adds the model's levels to the building in the Skeleton.
- The hint - the button stays off until the BIM is mounted to one building.
- The model's levels - each with its elevation. Exists shows whether the building already has a matching level.
- Origin (BCS) - Manual selection or Shared Coordinate; see Align Design References.
- Horizontal (X-Y) and Height (Z) - both are required. Set up lets you pick them in the model.
- Mark Aligned - available once the origin is set. Only an aligned model can be mounted.
Get the model ready
- On 3D Views, choose which views to publish, and star the default one.
- Open Alignment, set the origin, and click Mark Aligned. Every option is in Align Design References.
- Click Save.
- Mount the model to its building, then come back to Levels and click Populate Levels to Building if the building needs the model's levels.
Next: Align Design References - place drawings and models in the project.